2 min read

An Aluminum Refinery Faces Premature Gearbox Oil Changes

Wed, Dec. 14, 2016

The ApplicationYarwun refinery

An Australian aluminum refinery was consistently performing premature gearbox lube oil changes on seven base drive units due to oil and particulate contamination.

With an average operating ISO code of 20/18/16 and average water levels of 4742ppm, the 360 liters / 90 gallons of ISO VG320 gear oil was being changed far too often. Cost per gearbox oil change (excluding crane, lost production, labor) is $17,962.60 which adds up to $125,738.20 for all seven units.

shell The Solution

Conditioning gearbox lube oil is a huge opportunity for savings. By removing dirt and water the lube oil can be used until another characteristic of the oil fails (i.e. viscosity or additive) which can result in exponentially longer fluid life and prevent gearbox failure. 

To remove the particulate and water from the oil, a Hy-Pro V5 vacuum dehydrator was selected to address all three phases of water (free, dissolved, emulsified) and remove particulate with an oversized 3M (β5[c] > 1000) filter element. The V5 was rotated between the seven top drives on a two-day service interval rapidly purifying the oil by turning the sump volume 75 times daily.

The Results

On each unit, water was rapidly reduced an average of 98% from 4742ppm to 96ppm. Particulate contamination size 4μ[c] and larger decreased by 95% as average ISO codes decreased from 20/18/16 to 15/13/8.

The refinery increased reliability and profitability while reducing the environmental impact of premature oil disposal. Oil life has been extended reducing the need for oil changes. Gearbox life should also triple under these conditions leading to even more substantial savings.

Aluminum Refinery Gearbox Case Study

Written by Jim Harlan


Sign up for updates